Con-Serv, Inc. - Quality Slide Bearings For All Industries

Quality Slide Bearings For All Industries

Search Catalog
 CON-SLIDE™    Type CSB (2000 PSI to 4000 PSI)
CON-SLIDE™ > Type CSA & CSB Bearings > Type CSB (2000 PSI to 4000 PSI) > Item # CSB Upper 03SS 37CT  

Item # CSB Upper 03SS 37CT, Type CSB (2000 PSI to 4000 PSI)

    border="0" Printable Page  
    Email Email This Page  
    Save To Favorites Save To Favorites

This blend (CSB) was formulated for use against a smooth stainless steel surface.
The CSB system consists of an upper and lower element. The PTFE surface (1 only) is on the lower element. It is nominally 1/16" thick and is control-bonded to a 10-gauge carbon steel (CS) back-up sheet. The upper element is composed of a 20-gauge stainless steel (SS) sheet (RMS<20) resistance welded to a 10-gauge carbon steel (CS) back-up sheet.
The blended CSB material used for this bearing is composed of virgin (unreprocessed) PTFE resin tested per ASTM 04894 or ASTM D4895 and reinforcing agents including milled glass fibers. This structural material has the following representative mechanical and physical properties:
  • Tensile Strength: 3300 psi
  • Elongation: 300%
  • Specific Gravity: 2.11 - 2.21
    Actual values per lot are available upon request which might vary due to processing factors.
    The design engineer shall determine the square inches of bearing area required for the lower element by dividing the load by the allowable pressure from the graph. The upper element is sized for the movement after the lower element is sized for load.
    CON-SERV Inc can supply any practical size cut from stock steel. Size is out to out of back-up plate.
    For ease of installation, CON-SERV recommends a back-up plate 1" larger than the CSA or CSB size to allow a 1/2" recess all around. This recess must be provided for plates requiring a seal weld.
    Certifications on the epoxy, steel and CSB material are available upon request. Welded to a 10-gauge carbon steel (CS) back-up sheet.

  •  Specifications   Altenate Specifiers   Coefficient of Friction   Guidelines   Guide Specification    Installation of CON-SLIDE Bearings   





    Slide Surface Thickness

    20 GA

    Slide Surface Material

    Stainless Steel

    Back-Up Plate Thickness

    3/8" PL

    Back-Up Plate Material

    Corten Steel


    12" x 12"

    Tensile Strength

    3500 psi


    300 %

    Specific Gravity



    ·  Temperature Vs. Allowable Load

    ·  Coefficient of Friction Vs. Load

    ·  Slots & Holes


    Con-Serv, Inc.
    Quality • Service • Economy

    1-800-541-1044 / Fax 843-546-1055
    685 Aviation Blvd. • Georgetown, SC 29440