Products Catalog

CON-SERV Inc will supply elastomeric bearing pads to provide structural support in bridges as well as commercial and industrial buildings, petro-chemical and power plant applications. These parts, depending on the type of elastomer, provide uniform load transfer, accommodate thermal movement, allow for end-beam rotation and isolate components of the structure against vibration, noise and shock.
CON-SERV Inc designs and produces both AASHTO grade neoprene pads as well as AASHTO grade preformed fabric pads. These pads can also be supplied with filled Teflon® (PTFE) bonded to them for use as the lower element in a slide bearing which will provide for longitudinal movement as well as the rotation required.

Plain and shimmed bearings are available in standard Shore A durometers of 50, 60 or 70 based on state and/or AASHTO Code, Section 18, natural rubber or neoprene. For economy, a commercial grade is also available.
PTFE surfaced neoprene backed slide bearings are also available. Type CSA material is recommended bonded to a 10 GA. steel laminate which has in turn been bonded to neoprene. If minimum dead load pressure is less than 200 psi, it is recommended that the elastomer be epoxy-bonded to concrete. If on steel, a tack plate is recommended for positive reinforcement. The maximum temperature at a neoprene bearing is 200°F.

1 - 7 of 7 | Results Per Page | View | Unit of Measure
1 

Item #

Element

Type

Material

Quantity
Sort by
N/A Upper N/A NES NEP N/A Shimmed Neoprene Plain Neoprene
N/A Lower N/A NES NEP N/A Shimmed Neoprene Plain Neoprene
N/A Lower N/A NES NEP N/A Shimmed Neoprene Plain Neoprene
N/A Lower N/A NES NEP N/A Shimmed Neoprene Plain Neoprene
N/A Lower N/A NES NEP N/A Shimmed Neoprene Plain Neoprene
N/A Lower N/A NES NEP N/A Shimmed Neoprene Plain Neoprene
N/A Alternate Lower N/A NES NEP N/A Shimmed Neoprene Plain Neoprene
1 - 7 of 7 | Results Per Page | View | Unit of Measure
1